| Frequency coverage: |
Amateur bands 1.8 – 29.7 MHz including WARC + 50 MHz |
| Power output: |
2000+ W in SSB/CW on HF bands, 1500 W in RTTY
1500 W CW/SSB on 50 MHz |
| Drive power: |
40 to 60 W for full output power |
| Input impedance: |
50 Ohm VSWR < 1.5 : 1 |
| Output amplification: |
17 dB |
| Output impedance: |
50 Ohm unbalanced |
| Maximum output SWR: |
3:1 |
| SWR protection: |
Automatic switching to STBY when reflected power is 350W or higher |
| Intermodulation distortion: |
better then -32 dBc |
| Suppression of harmonics: |
min -50 dBc (30–54 MHz better than -70dBc) |
| Response speed of AUTO tune: |
less than 0,5s within same BAND ,less than 3s if out of BAND |
| Supported TRXs-CAT: |
ICOM, ELECRAFT, KENWOOD, TEN-TEC ORION, YEASU,
Icom transceive protocol using by microHAM devices – CI-V OUPUT,
Flex Radios and Anan ( Apache Labs ) |
| Tube: |
FU-728F ceramic tetrode |
| Cooling: |
Centrifugal blower + axial blower |
| Power supply: |
Switchable 220,230,240V – 50/60 Hz or other primary voltages
(for example 200V 50/60Hz for Japan) |
| Transformers: |
1 toroidal transformer 3.0 kVA |
| Protection circuits: |
- VSWR too high |
| |
- Anode current too high |
| |
- Anode voltage error |
| |
- Screen current too high |
| |
- Screen voltage error |
| |
- Grid current too high |
| |
- Grid voltage error |
| |
- Heating voltage error |
| |
- Mistuning of power amplifier |
| |
- Temperature to high |
| |
- Soft start for fuse protection |
| |
- “switch –on blocking“ at opened amplifier |
| Indications: |
4.3" color touch screen display |
| Features: |
- Automatic external Antenna switching |
| |
- Automatic switching between bands |
| |
- Automatic tuning within the band according to segments |
| |
- Automatic switching of Band Pass Filter |
| |
- Memory for faults and warning, easy maintenance |
| |
- Automatic set-up anode current (BIAS) – no need to manual adjust after changing the tube |
| |
- Three programmable working modes of centrifugal blower ( turbine ) + axial blower |
| |
- T/R System: QSK operation with built-in vacuum RF antenna relay |
| |
- Easy transport due to detachable HV transformer |
| |
- Remote control - connector for LAN connection |
| |
- The Power Amplifier is HF sensitive (automatic frequency reading even if no CAT) |
| |
- The smallest and lightest 2000 W automatic PA on the market |
| Mechanical parameters: |
390mm x 195mm x 370mm (width x height x depth) |
| Weight: |
24 kg |
